Knowing how to change a tyre is a necessary skill for all drivers. Thankfully, changing a tyre isn’t all that hard! Just adhere to the following guidelines to be prepared in case you have a flat.
To change car tires, follow these steps:
1. Find a safe location:
Park your car on a flat and level surface away from traffic. Engage the parking brake and turn off the engine.
2. Gather necessary tools:
You’ll need a lug wrench, a jack, and a spare tire. These tools are usually provided with your car.
3. Loosen the lug nuts:
Use the lug wrench to loosen the lug nuts on the tire you want to change. Turn them counterclockwise but don’t remove them just yet.
4. Position the jack:
Refer to your car’s manual to identify the proper jack points. Place the jack securely under the vehicle frame near the flat tire.
5. Lift the car:
Use the jack to raise the car until the flat tire is slightly off the ground. Be cautious and ensure the car is stable before proceeding.
6. Remove the lug nuts and old tire:
Completely unscrew and remove the lug nuts. Carefully pull the flat tire straight off the hub and set it aside.
7. Mount the spare tire:
Align the spare tire with the wheel studs and push it onto the hub. Make sure it is flush against the hub.
8. Tighten the lug nuts:
Behind the word mountains, far from the countries Vokalia and Consonantia, there live the blind texts. Separated they live in Bookmarksgrove right at the coast of the Semantics, a large language ocean.
9. Lower the car:
Carefully lower the car using the jack until all four wheels are on the ground.
10. Tighten the lug nuts again:
Give the lug nuts one final tightening using the lug wrench. Ensure they are properly secured.
11. Stow the flat tire and tools:
Place the flat tire and tools in your car’s trunk or a designated storage area.
12. Check tire pressure:
Use a tire pressure gauge to check the pressure of your spare tire. Adjust the pressure if needed.
13. Repair or replace the flat tire:
Take the flat tire to a professional tire shop to be repaired or replaced.